PREPARATION OF THE SUPPORT AND APPLICATION CYCLE

New wood. It must be cleaned dry, sanded and dusted. Apply a coat of STPROTETTIVO (UV) with a brush or a soft pad and leave to dry for 24 hours. In the case of particularly dry wood, it may be necessary to repeat the application a few times, spacing 1-2 hours between applications.

Old wood. Wet the wood with fresh water and apply STDETERGENTE homogeneously over the entire surface, leaving it to act for about 5-10 minutes. Brush with broom or nylon brush to remove any traces of grease, oil or salt. Rinse thoroughly with fresh water. If it is necessary to lighten the color of the wood or the blackish stains caused by natural aging, apply STSBIANCANTE with a brush on the wet surface. Rub with a broom or nylon brush and rinse thoroughly with fresh water, leaving to dry for 24 hours. In the case of persistent stains, repeat the operation again with STSBIANCANTE. Apply a coat of STPROTETTIVO (UV) with a brush or a soft pad and leave to dry for 24 hours. In the case of particularly dry wood, repeat several applications, leaving 1-2 hours between coats. In hot conditions it may be necessary to repeat the application on those parts of the surface where the wood is more faded or worn

Type

Application