MARLIN ANTIFOULING VELOX PLUS 0.250ML

Acrylic-based antifouling for propellers, motor feet and flaps with high adhesive power and resistance to strong stresses

It is applied in 2 coats, after applying 1 coat of base type Eliprimer on propellers sanded with coarse-grained paper and degreased with water-soluble detergent (do not use solvents to degrease)

It is applied directly on previous layers of paint if well anchored

Do not apply on previous antifoulings of a different type

Pack of 250 ml

PREPARATION OF THE SUBSTRATE AND APPLICATION CYCLE:

Unpainted metal supports. Proceed with a thorough degreasing, washing and sanding of the surface. Apply a base coat such as ELIPRIMER. Overpaint with 2 coats of CONTENDER ELICHE respecting the recommended overpainting times.

Supports already painted. If the old paint is in good condition and compatible, apply directly after sanding 2 coats of CONTENDER ELICHE. If the old varnish is in bad condition, proceed with its complete removal; then follow the instructions for unpainted substrates.

Recommendations. The maximum period of commissioning of the antifouling, after the application of the last coat, is 1 month; with top-of-the-range products based on copper oxide and after agreement with our. technical personnel, the same can extend up to 3 months, provided that the hull is protected from humidity, rain, or atmospheric agents, with plastic or similar material.

Color. The color of the antifouling after immersion may undergo a slight variation. There may be small differences in color between different production batches: in this case, mix them before application.