PREPARATION OF THE SUBSTRATE AND APPLICATION CYCLE

Iron. Apply a coat of EPOZINC 2C or EPOFOND AM-9 to grade 2.5 sandblasted iron. If sandblasting is not possible, the surface should be clean, dry, degreased and free from rust or traces of calamine. Any badly anchored paints must be removed mechanically. Apply 2 coats of EPOFOND AM / 9 and fill with PLAMUR FINISHER MDF if necessary. Apply a coat of POLIFOND and sand down after 24 hours. Overpaint with 2 coats of ACRIGLASS SMALTO respecting the overpainting times.

Fiberglass. The surface must be degreased with a suitable detergent, rinsed, lightly sanded with fine sandpaper and dusted. If the surface is slightly chalky, it is advisable to sand and apply 1 coat of POLIFIBER PRIMER, waiting 18-24 hours between coats. Possible grouting with PLAMUR FINISHER MDF. Overpaint with 2 coats of ACRIGLASS SMALTO in the chosen color.

New wood. The wood must be cleaned dry and seasoned and possibly treated with an impregnating coat of POLIGLASS varnish diluted 50-75% or more, with Thinner 203. After 24 hours, sand and apply 2 coats of ACRIGLASS SMALTO at intervals of 24 hours each. other.

Already painted wood. Carry out a compatibility test by painting a small part of the existing coating; in the presence of softening or opacification it is advisable to bring the wood back to new by completely removing the old paint. Follow the signs for new wood. If the previous finish was two-component polyurethane in good adhesion conditions, clean, sand and apply 1 coat of POLIFOND. After 12-24 hours, sand and paint over with 2 coats of ACRIGLASS SMALTO in the chosen color.